Service Manual

Rev. A
Reelmaster 5200-D/5400-DPage 8 - 2Cutting Units
(Model 03506, S/N 80001 - 209999999)
(Model 03509, S/N 80001 - 209999999)
Specifications
Figure 1
Reel Construction
5 or 8 blade welded construction with 5 inch diameter.
Height-of-Cut
5-blade: 1/2 to 3/4 inch (1.27 to 1.91cm)
8-blade: 1/4 to 5/8 inch (0.64 to 1.59 cm) using
Standard Rear Roller Kit (2 inch dia.) Model 03525
5/16 to 5/8 inch (0.79 to 1.59 cm) using Pre-
mium Rear roller Kit (2.5 inch dia.) Model 0323
Roller Adjustment
Front: Fixed
Rear: Screw adjustable with bolt clamp lock
Bedknife-to-Reel Adjustment
Bedknife adjusts against the reel with opposing screw
adjustment on each end of the bedbar.
Bedknife Screw Torque
180 to 200 in-lb (20.3 to 22.6 N-m)
Reel Spline Drive Nut Torque
40 to 60 ft-lb (54 to 81 N-m)
Reel Bearing Roller Torque
4 to 7 in-lb (0.45 to 0.79 N-m) with no end play