Operator's Manual
!"=# !" #"!
-+85)
))/ 5-9) 27252817-1+ 876
Detach chain from lift arm and secure it to cross
tube on each rear cutting unit with a capscrew,
flatwasher and locknut (Fig. 13).
-+85)
2'. #3 ,%-1
"" %.) 685) %// ,<(5%8/-' ,26)6 %5)
5287)( %:%< *520 '877-1+ 81-7 62 :,)1 '877-1+ 81-7
3-9276 );')66-9) 58&&-1+ (2)6 127 2''85
Check adjustment of lock-up rollers (Fig. 14).
When properly adjusted, they will contact the lock-up
levers on rear lift arms and support the cutting units
when fully raised. The cutting units should have
approximately 3/8"- 5/8" vertical travel measured at
the rear roller.
-+85)
2'.83 2//)562'.83 )9)56
Mount a basket to each cutting unit carrier frame
by inserting basket mounting pin into basket bracket
and depressing opposite mounting pin into pivoting
bracket.
!" $"
The Reelmaster 5200-D & 5400-D Traction Units comply with ANSI B71.4-1990 and EN836 Standards when
equipped with rear weight and 90 lbs. of calcium chloride ballast is added to rear wheels. Use chart below to
determine combinations of weight required. Order parts from your local Authorized Toro Distributor.
)%5 $)-+,7
)48-5)(
$)-+,7 %57
80&)5
$)-+,7
)6'5-37-21
7<
:( "5%'7-21 #1-7 :-7,
! :2 &%6.)76
/&
)%5 $)-+,7 -7
:( "5%'7-21 #1-7 :-7,
! :-7, &%6.)76
/&
)%5 $)-+,7 -7
:( "5%'7-21 #1-7 :2
! :2 &%6.)76
/&
)%5 $)-+,7 -7
:( "5%'7-21 #1-7 :2
! :-7, &%6.)76
/&
)%5 $)-+,7 -7
:( "5%'7-21 #1-7 :-7,
! :2 &%6.)76
/&
)%5 $)-+,7 -7
:( "5%'7-21 #1-7 :-7,
! :2 &%6.)76
/&
)%5 $)-+,7 -7
)%5 $)-+,7 -7 /&
"" * % 381'785) 2''856 -1 % 7-5) :-7, '%/'-80 ',/25-() 5)029) 81-7 *520 785* %5)% %6 48-'./< %6
3266-&/) "2 35)9)17 3266-&/) (%0%+) 72 785* -00)(-%7)/< 62%. %**)'7)( %5)% :-7, :%7)5