Service Manual

Solenoid Valve Coil Replacement

1. Park machine on a level surface, engage parking

brake, lower the cutting units and turn engine OFF.

2. Disconnect solenoid electrical connector.

3. Remove nut from solenoid.

4. Remove solenoi

d coil.

5. Install new solenoid coil and secure with nut. Apply

“Locktite 242" or equivalent to threads on end of stem

tube before installing nut. Tighten nut to a torque of

15 in-lb. Over-tightening may damage the solenoid or

cause the solenoid valve to malfunction.

Figure 41

6. Connect electrical wiring connector.

1. Solenoid

Solenoid Wire Identification

Solenoid Power W ire Color

1 Pink/Blue

2 Brown/White

3 Orange/Blue

4 Yellow/Black

5 Yellow/W hite

6 Orange/Red

7 Yellow/Blue

8 Black/ Red

9 Brown/White

VS1 Orange/Black

VS2 Orange/White

Figure 42

Repairs Page 5 - 36 Reelmaster

5100-D