Operator's Manual
8
LOOSE PARTS CHART
Note: Use this chart as a checklist to assure all parts necessary for assembly have been received. Without these
parts, total setup cannot be completed. Some parts may have already been assembled at factory.
Wheel Assy 1
Flat washers 2 Install rear wheel on model 03422
Castor Axle 1
Locknut 1
Wheel Assy. 1 Install rear wheel on model 03427
Lug Nuts 4
Flat Washer 3 Mount carrier frames to cutting Units
Capscrew 3 (supplied with Lift Arm kit)
Locknut
Lift Arms 2
Pivot Rod 2
Capscrews5/16- 18 x 7/8"Lg. 2
Lockwashers 2 Install front lift arms
Lift Chains 2 (supplied with Lift Arm kit)
Clevis Pin 4
Cotter Pin 4
Thrust Washers 3
Flat Washer 3 Mount cutting units to lift arms
Flange Head Capscrew 3 (supplied with Lift Arm kit)
Spring 3
Vinyl Sleeve 1
Spring Shackle 3 Install counterbalance springs
Clevis Pin 6 (supplied with Lift Arm kit)
Cotter Pin 6
Key 2
Hydraulic Reservoir Plug 1
Operators Manual 2 Read before operating machine
Parts Catalog 1
Registration Card 1 Fill out and send to the Toro Co
Specifications and design subject to change without notice.