Service Manual

Adjusting Tracton Pedal (Reelmaster 216) (Fig. 26, 27)
If traction pedal contacts footrest when pushed fully
forward or you cannot get maximum forward traction
speed, an adjustment to the traction pedal linkage is
required. There should be 3/8 inch clearance between
pedal shaft and footrest when pedal is pushed fully
forward.
1. Remove (3) self-tapping screws securing support
screen to hydraulic support panel. Remove screen.
2. Loosen jam nuts on each end of traction rod.
3. Rotate rod to get a dimension of 3/8 inch between
traction pedal shaft and R.H. footrest when pedal is
pushed fully forward.
Figure 26
4. Re-tighten jam nuts securing traction rod and reinstall
1. Support screen
support screen.
5. The stop for reverse travel (under pedal) may be
adjusted for slower travel. Speeds in excess of 3 M.P.H.
are not recommended.
Figure 27
1. Traction rod
Adjustments Page 5 - 26 Reelmaster
®
216/216-D