Service Manual

Test Hook-up No. 4: Traction Pressure (Fig. 21)

Gauge Connection

Connect a 10,000 PSI hydraulic pressure gauge to

forward traction pressure gauge port.

TEST A: Traction Pressure

1. Make sure pump drive belt is properly adjusted and

in good condition.

2. Make sure hydraulic oil is at operating temperature.

3. Operate engine at full speed:

Reelmaster 216: 3600 ± 100 RPM

Reelmaster 216-D: 3200 ± 100 RPM

4. Attach a heavy chain to rear frame of machine and

then to something solid in shop. Engage parking brake.

CAUTION

Keep everyone clear from the front of unit

during traction system tests. Operator must

be on seat or the safety interlock will stop the

engine when the traction pedal is depressed.

Figure 21

1. 10,000 PSI hydraulic pressure gauge

5. While watching pressure gauges, slowly push traction

pedal into forward until maximum pressure is obtained.

GAUGE READING: 4000 – 4500 PSI.

Testing Page 5 - 22

Rev. A

Reelmaster

216/216-D