Service Manual

2WD/3WD Two Position Valve
5
3
6
13
5
15
15
12
13
9
15
11
13
8
7
10
13
1
14
2
4
SKIRT ASSEMBLY
Figure 51
1. Two position valve
6. Hydraulic connection
11. Hydraulic fitting
2. Nut
7. Hydraulic connection
12. Hydraulic fitting
3. Cap screw
8. Hydraulic connection
13. O–ring
4. Tub clamp
9. Hydraulic
connection
14. Cap screw
5. Hydraulic tube
10. Hydraulic fitting
15. O–ring
Removal (Fig. 51)
5. Disconnect hydraulic connections (6, 7, 8 and 9)
from hydraulic fittings (10, 11, and 12). Allow hydraulic
1. Before removing any parts from the hydraulic man-
oil to drain from tubes into a suitable container.
ifold, park the machine on a level surface, engage the
parking brake, lower the cutting units and stop the en-
6. Remove cap screws (14) from two position valve
gine. Remove the key from the ignition switch.
(1).
CAUTION
Operate all hydraulic controls to relieve
system pressure and avoid injury from
pressurized hydraulic oil.
7. Remove fittings (10, 11, and 12) and O–rings (15)
from two position valve (1).
Installation (Fig. 51)
1. Install hydraulic fittings (10, 11, and 12) and O–rings
(15) into two position valve (1).
2. Secure cap screws (14) to two position valve (1)
2. Clean two position valve (1) and hydraulic fittings.
through the skirt assembly
.
3. Put caps or plugs on any hydraulic lines or fittings
3. Install hydraulic connections (6, 7, 8 and 9) to hy-
left open or exposed. Put labels on disconnected hy-
draulic fittings (10, 11, and 12) and tighten fittings.
draulic lines and hoses for proper reassembly.
4. Tighten nut (2) and cap screw (3) so the tube clamps
4. Loosen nut (2) and cap screw (3) so the tubes
(4) will prevent movement of the hydraulic tubes (5).
clamps (4) will allow movement of the hydraulic tubes
(5).
Hydraulic System Page 4 – 54 Reelmaster 2300–D/2600–D