Service Manual

Reelmaster 3100--D
DPA Cutting Units
Page 8 -- 7
Reel Bearing Installation Tool (cutting units with painted side plates)
Toro Part Number: 117 -- 0975
Use the reel bearing installation tool to keep the reel
bearing aligned as the cutting unit side plate is installed
on the bearing.
Figure 11
Cutting Reel Shim
Toro Part Number: 125--5611
The cutting reel shim (0.002”) is used to help parallel the
bedknife and cutting reel.
Figure 12
Cutting Performance Paper
Toro Part Number: 125--5610
Cutting performance paper is used to test the cutting
reel performance after adjusting the reel to bedknife
clearance. 10 packs (30 strips per pack) of cutting per-
formance paper are included in this part number.
Figure 13
Pulley Alignment Tool
Toro Part Number: 114 -- 5446
Use pulley alignment tool to verify alignment of groomer
and/or rear roller brush drive and driven pulleys.
Figure 14
DPA Cutting
Units