Service Manual

Reelmaster 3100−D
Page 4 − 117
Removal
1. Remove rear lift cylinder from the frame and lift arm
using Figure 82 as guide.
2. If hydraulic fittings are to be removed from lift cylin-
der, mark fitting orientation to allow correct assembly.
Installation
1. If hydraulic fittings were removed, install fittings to lift
cylinder using marks made during the removal process
to properly orientate fittings.
2. Install rear lift cylinder to the frame and lift arm using
Figure 82 as guide.
3. Adjust rear lift arm (see Adjust Rear Lift Arm in Chap-
ter 7 − Cutting Units).
Hydraulic
System
Hydraulic System