Operator's Manual
Table Of Contents
- NO TITLE
- .
- 1 Installing the Wheels
- 2 Installing the Steering Wheel
- 3 Activating, Charging, and Connecting the Battery
- 4 Checking the Angle Indicator
- 5 Installing the CE Decal
- 6 Installing the Hood Latch (CE Only)
- 7 Installing the Exhaust Guard (CE Only)
- 8 Installing the Roll Bar
- 9 Installing the Front Lift Arms
- 10 Installing the Carrier Frames to the Cutting Units
- 11 Mounting the Cutting Units
- 12 Mounting the Cutting Unit Drive Motors
- 13 Adjusting the Lift Arms
- 14 Installing the Tipper Roller Kit (Optional)
- NO TITLE
- NO TITLE
- Think Safety First
- Checking the Engine-Oil Level
- Filling the Fuel Tank
- Checking the Cooling System
- Checking the Hydraulic System
- Checking the Tire Pressure
- Checking the Reel-to-Bedknife Contact
- Torquing the Wheel Nuts
- Starting and Shutting Off the Engine
- Bleeding the Fuel System
- Checking the Interlock System
- Identifying the Tie-Down Points
- Hauling the Machine
- Towing the Machine
- Using the Standard Control Module (SCM)
- NO TITLE
- NO TITLE
- NO TITLE
g011213
Figure5
1.Positive(+)batterycable2.Negative(–)batterycable
Important:Ifthebatteryiseverremoved,make
surethatthebatteryclampboltsareinstalledwith
theboltheadspositionedonthebottomsideand
thenutsonthetopside.Iftheclampboltsare
reversed,theymayinterferewiththehydraulic
tubeswhenshiftingthecuttingunits.
9.CoatbothbatteryconnectionswithGrafo112X(skin
over)grease,ToroPartNo.505-47,petroleumjelly,or
lightgreasetopreventcorrosion.
10.Slidetherubberbootoverthepositiveterminalto
preventapossibleshortfromoccurring.
11.Installthebatterycover.
4
CheckingtheAngleIndicator
Partsneededforthisprocedure:
1Inclinometer
Procedure
DANGER
Toreduceriskofinjuryordeathduetorollover,do
notoperatethemachineonsidehillssteeperthan
25º.
1.Parkthemachineonaat,levelsurface.
2.Verifythatthemachineislevelbyplacingahandheld
inclinometer(suppliedwiththemachine)ontheframe
crossrail,bythefueltank(Figure6).Theinclinometer
shouldreadzerodegreeswhenviewedfromthe
operator’sposition.
g008873
Figure6
1.Angleindicator
3.Iftheinclinometerdoesnotreadzerodegrees,move
themachinetoalocationwhereazerodegreereading
isobtained.Theangleindicator,mountedonthe
machine,shouldnowreadzerodegreesaswell.
4.Iftheangleindicatordoesnotreadzerodegrees,loosen
the2screwsandnutssecuringtheangleindicatorto
themountingbracket,adjusttheindicatortoobtaina
zerodegreereading,andtightenthebolts.
5
InstallingtheCEDecal
Partsneededforthisprocedure:
1
Warningdecal(121-3598)
Procedure
IfthismachinewillbeusedforCE,afxtheCEdecalover
thecorrespondingnon-CEdecal.
17