Operator's Manual

g353280
Figure30
1.Jamnut
3.Lift-armplate
2.Stopbolt4.0.13to1.02mm(0.005to
0.040inches)gap
3.Repeatstep2atthestopboltfortheotherlift
arm.
4.Starttheengine,lowerthecuttingunits,shut
offtheengine,removethekey,andwaitforall
movingpartstostop.
AdjustingtheRearCuttingUnit
Clearance
1.Loosenthejamnutoftheliftcylinder(Figure31).
g008880
Figure31
1.Liftcylinder(rearcutting
unit)
2.Jamnut
2.Graspthecylinderrodclosetothenutwitha
pliersandrag,androtatetherod.
Note:Shorteningtherodreduceswearstrap
andbumperstopclearance.
3.Starttheengine.
4.Raisethecuttingunitsandmeasurethe
clearancebetweenthewearstraponthetopof
therearcuttingunitwearbarandthebumper
stop.
Thecorrectclearanceis0.51to2.54mm(0.02
to0.10inch).
5.Repeatsteps1through4asneeded.
6.Lowerthecuttingunits,shutofftheengine,
removethekey,andwaitforallmovingparts
tostop.
7.Tightenthejamnut.
11
AdjustingTireAirPressure
NoPartsRequired
Procedure
Adjustthetireairpressureateachofthetires;referto
CheckingtheTirePressure(page54).
Note:Thetiresareover-inatedforshipping.
12
InstallingtheHoodLatch
CEMachines
Partsneededforthisprocedure:
1Lockbracket
2Rivet
1Washer
1
Screw(1/4x2inches)
1
Locknut(1/4inch)
Procedure
1.Unhookthehoodlatchfromthehood-latch
bracket.
2.Removetherivets(2)securingthehood-latch
brackettothehood(Figure32).Removethe
hood-latchbracketfromthehood.
24