Installation Manual
Table Of Contents
- X-22 Excavator Indicate System Installation and Calibration Manual
- Table of Contents
- Introduction
- Installation and Calibration
- Getting Started
- Step 1: Charge the Sensors
- Step 2: Attach the Brackets
- Step 3: Attach the Mast for the PitchRollCompass
- Step 4: Attach the X-22 Display
- Step 5: Measure the Excavator
- Step 6: Entering the Sensors on the X-22 Display
- Step 7: Attach the Sensors to the Excavator
- Step 8: Calibrate the Sensors
- Step 9: Measure and Calibrate the Buckets
- Finding Your Way Around the Software
- Before You Start to Dig
- Important Information On Use
- Machine and Bucket Measurements
- Getting Started
- Troubleshooting
- The X-22 Display is not responding, what should I do?
- The sensors are not responding, what should I do?
- A sensor is damaged, what should I do?
- How do I recalibrate a sensor?
- The system is not measuring accurately, what should I do?
- The compass is measuring incorrectly, what should I do?
- The laser sensor is not working, what should I do?
- Specifications
- Safety Warnings
- Regulatory Information
- Warranty Terms
- Back Cover
X-22 Installation and Calibration Manual
2-18
Each sensor has a unique serial number, which can be found on the
back of the sensor preceded by “SN:”. It is important to keep the
serial numbers of all the sensors for reference, and we recommend
making a note of them in the table below. It is not possible to
communicate with the sensor without the serial number.
NOTICE
It is important to take all the sensors out of the
charger before starting to enter them on the X-22
Display. The radio for the sensors is switched off
when they are in the charger.
Sensor Serial Number
Boom
Arm (Stick)
Bucket
PitchRollCompass
ArticBoom
Tilt Bucket