User Instructions

2. Fold a crease near one end of the piece of covering, then use your Trim
Seal Tool to iron it down into the corner.
3. Use the sealing iron to iron the piece down.
Overlapping the edges of different pieces of covering thoroughly
seals the covering to the part. There are instances where it’s
best to underlap trim pieces, or overlap larger pieces, or both
as shown below:
4. Use a single-edge razor blade or a
hobby knife to trim the covering the
desired distance from the surface (1/8”
[3mm] is typical). You can make a cutting
guide like the one shown in the photo
from a balsa or hardwood stick.
5. Slit the covering at each corner to fold it over.
6. Use your Trim Seal Tool to iron the
edges down to the wing.