User Instructions

5. Use your trimming guide to trim the covering the desired overhang –
approximately 1/8” [3mm] is suitable in most areas such as this.
6. Cut small “petals” into the overhang material around curved edges – the
tighter the curve the smaller the petal.
7. Use your Trim Seal Tool to lightly pull and seal
each petal to the end of the wing.
8.
Examine the entire piece, looking for any areas not
shrunk or bonded to the wing. Use your covering iron
to repair any areas found.
The bottom of the wing is  nished. The top is covered the same way.
APPLYING TRIM
APPLYING TRIM
Use your creativity to make patterns for cutting trim colors and graphics; you can make stencils cut from thin cardstock
or manila folder material, use graphic cutting tools or a simple straightedge. The 2 in the example below was cut from
MonoKote with a template made from manila folder material.
When applying MonoKote over MonoKote, graphics are best applied wet with window cleaner. The solution is then
squeegeed out and allowed to dry overnight. This procedure usually eliminates any air bubbles that would have
formed between the two layers if the trim had been applied dry.
1. Wet the adhesive side of the trim piece with window cleaner.