WD, Assembly = Hanging the Fan{continued) Preparing for mounting install remote control Preparing for mounting 1.Remove the mounting bracket from the canopy by loosening he two canopy screws educated the Shaped slots, 2. Remove and save the'two canopy screwiness round Holes. Thistle enable you to remove the mo tinting bracket 1.Carefully push the canopy tithe bottom of the mounting bracket, make two sliding holes aligned to the two prominent screws on the-mounting bracket, and then turn clockwise anti it.
Q, Assembly — Attaching the Fan Blades 1.Fastening the blade to the motor Fasten the Blade t6 the fan-moor assembly by 5 § inserting the alignment post into the slot on the: bottom of the motor dnd tightening the per-installed Blade screws. 5 pinups screwdriver 2.Repeat this step for the remaining blade assemblies. 1. remove hire screws from the plate which on the motor. 2: ise these three screws assemble the light Kit fitter.
@ Use of remote control (ui {Hi Fanned High level 5 (HED Fanned Middle Elise @ Crow Fan Speed Low Level Ww Reverse Function LB LIGHT NOOSE Note: the remote control must match the same code receiver & Remote control wiring diagram FORAGING TEE RSE RE RL < Ground wire prs ii ALTER | GREEN A The motor white wire to the white "TO MOTOR N “wire.
ORE Put the ¢lip in the center of a blade. turn on the fan and if the shake persists, put the ¢lip in another blade until the shake is reduced. Then this blade will need the counterweight. Place the clip on the blade that needs the counterweight and try the best place to place it, from the center to the tip of the blade, until the wobble disappears. Paste the counterweight on the surface of the blade which near the clip, remove the clip and test the fan. if it keep staggering, put another counterweight.