Installation Instructions

ManualsBrandsTool Shop ManualsTool Storage72" 2-Drawer Metal Workbench with Pegboard Backing

For assembly assistance call

800-495-9278

Weekdays: 8:00 a.m. - 5:00 p.m. Central Time

ASSEMBLY INSTRUCTIONS

6’ WORKBENCH

SKU: 136-7423

Model: 01072

FIGURE 9

STEP 17

Align the drawer glides on the drawer assembly to the drawer mount glides and carefully

slide in. Pull the drawer in and out making sure the glides are locked together.

STEP 18

Place 5/8” Work Surface Board (Q) into place.

Congratulations! The assembly is complete.

2301 Traffic St. N

Minneapolis, MN 55413

6’ Workbench Manual Revised 8-19

Summary of content (4 pages)

PAGE 1
FIGURE 9 Q ASSEMBLY INSTRUCTIONS 6’ WORKBENCH SKU: 136-7423 Model: 01072 STEP 17 Align the drawer glides on the drawer assembly to the drawer mount glides and carefully slide in. Pull the drawer in and out making sure the glides are locked together. STEP 18 Place 5/8” Work Surface Board (Q) into place. Congratulations! The assembly is complete. For assembly assistance call 6’ Workbench Manual Revised 8-19 2301 Traffic St. N Minneapolis, MN 55413 800-495-9278 Weekdays: 8:00 a.m. - 5:00 p.m.
PAGE 2
Thank You for purchasing a high quality workbench from Decko Products. If you require any assistance with assembly, please contact us toll free at 1-800-495-9278. FIGURE 8 Tools Needed N • Rubber Mallet and Phillips screw driver. P O Assembly Tips • Fully read and understand these instructions before starting assembly. • Group similar parts together. • If the use of a mallet or hammer is required, use a block or cloth to protect the finish. • Assemble the workbench on a sturdy surface.
PAGE 3
FIGURE 6 G T F S V A B S T H C D E I STEP 11 Assemble the drawer frames by attaching two Drawer Beams (T) to two 18” Drawer Side Beams (S). J FIGURE 7 K U L M N O P Q R STEP 12 Attach inner drawer glides to the sides of the drawer side beams by pushing in and back. STEP 13 T S Place 3/8” Drawer Bottom (U) into drawer frame.
PAGE 4
FIGURE 3 A V C E I V J C L D H FIGURE 2 V L A B Open side facing out R E A D M B A M E FIGURE 5 FIGURE 4 A V B V J FIGURE 1 STEP 1 Assemble the left side of the workbench by attaching two 24” Beams (B) to the Front Post (M) and Back Post (L). Be sure to use the 1st & 2nd keyholes on the upper part of the posts. Assemble the right side of the workbench using the same procedure as above. If necessary use a rubber mallet to secure the parts together.