User Manual

Preparing your Remote LINK
3
EN
Pre-
par-
ing
your
Re-
mote
LINK
Inserting the batteries
1. Hold the sides of the Remote LINK and press the latch on
the back of the device to open the battery compartment.
2. Insert the batteries (2 x AAA/LR3) in the Remote LINK.
Make sure you insert the batteries in the correct way, as
shown inside the battery compartment.
3. Replace the battery cover.
Establishing a paired connection
The following instructions only apply if your Remote LINK has
not been connected to a TomTom LINK 300/310. Press any key
to turn on your Remote LINK and see “Understanding your
Remote LINK” to check the status of the device.
If the device is not paired with a LINK 300/310, then do the
following.
1. Make sure the LINK 300/310 is properly installed in the
vehicle.
2. Turn on the ignition.
3. Make sure there are no other vehicles installed with a LINK
300/310 located within a distance of 30 metres.
4. Press any key on your Remote LINK to switch it on.
If the LEDs on all three buttons are flashing, then the device
is not paired and you need to continue with the next step.
5. Press any two buttons at the same time until you hear a
sound.
Borna_Logbook.book Page 3 Thursday, January 21, 2010 9:53 AM