Owner manual

ManualsBrandsToa ManualsMicrophonesWM-3310H

Battery replacement

• A brand-new battery will provide the power enough to operate the unit

continuously for 10 hours.

• As long as the battery has sufficient power for the microphone to function

properly, the orange LED will light. When the orange LED starts to fade and

then flash, replace it with a new one.

Power/Battery lamp

(Orange LED)

7. OPERATION

Step 1. Plug the microphone's plug into the input connector

as illustrated.

Step 2. Make sure that the receiver and the wireless

microphone are of the same channel (frequency).

Step 3. If they are not identical in channel, you have to

adjust the channel switch.

Step 4. Press the power ON/OFF switch to turn on the

microphone.

The orange LED indicates the circuit is active.

Step 5. Make sure to press the ON/OFF switch again to

turn off the microphone after using.

8. OPERATIONAL HINTS

• The microphone's service distance is 3 – 100 m. When the microphone user moves in a facility, signal

dropouts (momentary losses of signal reception) may be encountered. These dropouts are caused by the

building's architectural designs or materials which block the travel of or reflect the radio signal. If this occurs,

the user needs to change locations for better signal reception.

• Dangle the antenna freely. If wound around the unit or tied into bundles, sufficient service distance cannot

be obtained.

• The proper operation of your wireless system may be interfered with by other system operating on the same

frequency. In such cases, change the operating frequency of your system. (As to dealing with the

interference, refer to the operating instructions of the wireless tuner.)

• Should you have any questions regarding the use or availability of TOA wireless products, please contact

your local TOA dealer.

9. DISTANCE BETWEEN THE MICROPHONE AND THE MOUTH

[Lavalier type version (WM-3310)]

Keep your mouth 15 – 20 cm away from the microphone for the best possible sound reproduction. Take care not

to bring your mouth too close to the microphone (within 5 cm) as this impairs speech clarity if you speak loudly.

[Headset type version (WM-3310H)]

By adjusting the gooseneck, locate the microphone with the supplied windscreen in front of your mouth, and

position it 3-5 cm away from your mouth for the best sound reproduction. When the microphone is too close to

your mouth or you speak too loud, speech clarity will be impaired, making it hard for the audience to hear

announcements.

10. CHANNEL NUMBER SETTING

Step 1. Slide the battery cover down to open it.

Step 2. Using the supplied screwdriver, set the channel

selector switch pointer to the desired channel number.

Step 3. Replace the battery cover.

Note

Make sure that the wireless microphone is identical to the wireless tuner in the channel number. Should the

microphone's setting differ from that of the tuner, the tuner does not receive the microphone signal.

Plug lock

Power ON/OFF switch

Secure the connection

with the plug lock.

CHANNEL