Powering on Press and hold the top button for 3s. Pairing for the first time Note: Always use the app to pair the watch with your phone. Do not attempt to use your phone's Bluetooth settings to directly search for and pair. 1 Install and launch the app (TINWOO) on your phone. Tap on the link icon at the top-right corner of the screen. 1.
Select the same serial number shown on your smartwatch. Follow the steps below to retrieve your watch's serial. 1st.Swipe left 3rd.Swipe Up 2nd.Settings T20- F1F1 v-1.3-006 4th.About Serial 2.
Tap on the same serial number on the app to get the pairing. connected！ FAQ 1.Watch wont pair anymore with smartphone. - Turn off your phone's Bluetooth. After that, completely power off your phone, then turn it on again. - Do not turn on your phone's Bluetooth yet. - Finally, launch the app (TINWOO). The app will prompt you to turn on your phone's Bluetooth. At this point, you can let the app turn it on. - Make sure the watch is on and running, it should also be as close to your phone as possible. 3.
- Now go back to the "TINWOO" app on your phone and tap on the link icon at the top-right corner of the screen. - That will bring up a list, with your watch likely to be the only device on that list. - Tap on it to pair and connect. Note: If it still fails to pair, please try any other smartphone. For any other phone that you wish to try, please make sure it is running either Android version 5.0 and above or iOS version 9.0 and above. 2.Screen is unresponsive to touch input.
-Our app (TINWOO) should be on this list. If it is already enabled, please disable it and then re-enable it again. -"Allow" or save if prompted to. For iOS / iPhone: - Open the iPhone's "Settings" app, then tap on "TINWOO" on the list below. - Toggle on "Notifications". If it is already on, turn it off, then on again. Note: Make sure pop up notifications are enabled for the apps you wish to monitor on the watch. Apps that have their pop-up notifications disabled may not get those alerts on the watch.
those moments. 6.Inaccurate sleep results. The sleep results can be affected by several factors and there are chances that the sleep might not be recorded if the "fall asleep criteria" (which is a set of complicated conditions depending on the amount of movement, wrist position and angle, and this will also change over time) is not fulfilled. The device will record the sleeping data from 8pm until next day 12pm only.
your smartphone. So you don't really have to keep it connected to the phone all day long. 8.Why is there a flashing light underneath the watch? How do you stop it? The flashing light indicates that the watch is currently monitoring a session (especially the pulse/heart rate) that you previously initiated but likely forgot to terminate. To stop it: - Navigate towards one of those sessions: usually pulse/heart rate. - Tap on the backwards arrow at the top of the screen to quit the session.
