Installation Guide

ManualsBrandsTicor ManualsFarmhouse/Apron Kitchen SinksBryce Farmhouse Apron Front 16-Gauge Stainless Steel 33 in. Single Basin Kitchen Sink with Accessory Kit

Apron Sink Installation Instructions

Please read these instructions carefully before beginning installation.

We recommend that apron sinks be installed by professional countertop installers

and we are not responsible for damages to the countertop or sink during installation.

TOOLS AND MATERIALS

Safety glasses tape measure pencil drill sealant

Plus: 1/2” or larger drill bit, hole saw 1-3/8”, support frame members, sanding block, assorted

sandpaper, orbital sander(optional).

BEFORE YOU BEGIN

1. Observe all local plumbing and building codes.

2. Inspect the drain and supply tubing. Replace if necessary.

3. Prior to installation, unpack the new sink and inspect for damage. To prevent damage, return the

sink to its original packaging until installation is ready.

4. The cabinet and frame shown in these instructions are generic and may not represent actual

design or structure.

5. Before proceeding, determine how far the sink will extend beyond the front of the cabinet. It

should extend a minimum of 1/2” (1.3 cm) and a maximum of 2-3/4” (7 cm).

6. Shut off the hot and cold water supplies.

7. As applicable, assemble the faucet and drain to the sink before installing the sink.

Summary of content (4 pages)

PAGE 1
Apron Sink Installation Instructions Please read these instructions carefully before beginning installation. We recommend that apron sinks be installed by professional countertop installers and we are not responsible for damages to the countertop or sink during installation. TOOLS AND MATERIALS Safety glasses tape measure pencil drill sealant Plus: 1/2” or larger drill bit, hole saw 1-3/8”, support frame members, sanding block, assorted sandpaper, orbital sander(optional). BEFORE YOU BEGIN 1.
PAGE 2
PREPARATION NOTE: You may use the provided brackets (Four) to tighten the sink flange to the countertop on the back side of the sink. Check with the countertop manufacturer for proper use of fastener. If you choose this option, you do not need to install the back support. 1. Install the water supplies and drain piping according to the roughing-in information. 2. Determine the faucet you will install. Make sure there is enough room between the backsplash or wall and back edge of the sink for your faucet. 4.
PAGE 3
INSTALL THE SINK 2. Install the strainer or garbage disposal to the sink according to the manufacturer’s instructions. 3. Apply a 1” (2.5 cm) spot of sealant at each corner of the frame where it will contact the sink. NOTE: If using shims additional sealant will be needed. 4. Carefully position the sink within the frame, making sure to center the sink in the cabinet. 5. Verify that the sink is level. The top of the sink should be flush with the top of the cabinet to allow proper countertop installation.
PAGE 4
laminate type countertops, waterproof all unprotected areas of wood. CARE AND CLEANING 11. Immediately wipe away any excess sealant with a damp cloth. Fill any voids between the rim and the countertop if needed. 8. Clean the top of the sink rim and the bottom of the countertop, making sure the surface is free from debris. 12. Allow the sealant to cure for at least 30 minutes before proceeding. 9. Apply a generous bead of sealant around the sink rim where the sink rim will contact the countertop. 13.