Owner Manual

ManualsBrandsThree Posts ManualsAll Ceiling Fans52'' Sybilla 5 - Blade Standard Ceiling Fan with Light Kit Included

Black (hot/power)

White (neutral)

Bare/Green

(ground)

White

Red

Black

White

Blue

White

Green

Receiver

1. Use existing pull chains on the desired

fan to set fan speed to HIGH and to turn

the light ON.

2. Turn o circuit breakers and wall switch

to the fan.

DANGER: Failure to disconnect

power supply prior to installation may

result in serious injury or death.

3. Lower the canopy of the previously

assembled fan and insert receiver.

Note: If installing this product with

a new fan, insert the receiver in the

mounting bracket before wiring the

fan; wire the fan according to these

instructions, then continue fan assembly

as directed in the fan’s instruction

manual.

UNIVERSAL

WALL REMOTE

4. Disconnect existing wire connections,

then secure all wire connections with

wire connectors according to diagram

and these steps:

• Connect the Blue wire with white label

from the receiver to the Blue fan wire.

• Connect the Black wire with white

label from the receiver to the Black fan

wire.

• Connect the White wire with white label

from the receiver to the White fan wire.

• Connect the Red wire with red label

from the receiver to the Black (hot/

power) supply wire.

• Connect the White wire with red

label from the receiver to the White

(neutral) supply wire.

Fan Pull

Chain

Light Pull

Chain

Canopy

Wall

Bracket

Mounting

Screw

5. Wrap electrical tape (not included)

around each wire connector down to

the wire. Then, push wire connections

into the outlet box. Place the White wire

connections on the opposite side of the

outlet box from the Black and Blue wire

connections.

6. Reinstall the canopy.

7. Turn on power supply and wall switch to

the fan.

8. Remove the battery cover from the back

of the remote and install the A23 12-volt

battery. Replace the battery cover and

press the HIGH SPEED button to ensure

the LED indicator illuminates and the

fan turns on.

9. If desired, the wall bracket can be

attached to a wall using the mounting

screws.

Remote

Qty. 1

Wall Bracket

Qty. 1

Battery

Qty. 2

Receiver

Qty. 1

Wire Connector

Qty. 5

Mounting Screw

Qty. 2

Owner’s Manual

Qty. 1

Read instructions completely before installing the remote.

WARNING: If the color of the household supply wires is different than what is referred to in the instructions below, a professional electrician should determine proper wiring.

CAUTION:

• Do not install in damp locations. For indoor use only.

• Do not use with fans that have integrated remote controls.

• Be sure the outlet box is properly grounded or that a green or bare (ground) wire is present.

• This unit is intended to control a ceiling fan with electrical source of AC 110/120V, 60Hz.

• To reduce the risk of re or electric shock, do NOT use a full-range dimmer switch to control the fan speed.

• CAN ICES-005 (B)/NMB-005 (B)

• Cet appareil est conforme aux normes d’exemption de licence RSS d’Industrie Canada. Son utilisation est soumise aux deux conditions suivantes : (1) cet appareil ne doit

provoquer aucune interférence; et (2) cet appareil doit accepter toute interférence, y compris les interférences pouvant entraîner un fonctionnement indésirable de l’appareil.

• This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help. Any changes or modications not expressly approved by the grantee of this device could void the user’s

authority to operate the equipment.

Owner’s

Manual

SAFETY INSTRUCTIONS

ASSEMBLY INSTRUCTIONS

1 5

2 6

Warning: Never wire fan to

a wall control. Only wire to a

single-pole on/o wall switch.

Canopy

Summary of content (2 pages)

PAGE 1
UNIVERSAL WALL REMOTE Owner’s Manual Remote Qty. 1 Receiver Qty. 1 Wall Bracket Qty. 1 Battery Qty. 2 Wire Connector Qty. 5 Mounting Screw Qty. 2 Owner’s Manual Qty. 1 SAFETY INSTRUCTIONS Read instructions completely before installing the remote. WARNING: If the color of the household supply wires is different than what is referred to in the instructions below, a professional electrician should determine proper wiring. CAUTION: • Do not install in damp locations. For indoor use only.
PAGE 2
OPERATING INSTRUCTIONS 1. To operate the fan using the remote, makre sure fan pull chain is on hight and light is turned on. Then press and release the following buttons: Fan Off - Turns the power to fan off. Light On/Off - Turns the light on and off. Press and hold to dim or brighten lights (for dimmable bulbs only). High Speed - Turns on fan at high speed. Light Delay - Light stays on for 60 seconds to allow for safe exit from room. Note: Tap Light Delay once to activate.