Use and Care Guide

Table Of Contents
en-us Getting to know your appliance
14
Ice pack
In the event of a power failure or a fault:
The ice pack delays the warming of stored frozen
food.
You can take out the ice pack to temporarily keep
food cool, e.g. in a cool bag.
Ice maker
9 CAUTION
DAMAGE TO THE APPLIANCE!
Never store bottles or food in the ice cube
container, even for short periods. This can
block and damage the ice maker.
Ice cube production starts as soon as the appliance
has reached the set temperature.
Notes
Ice cube production stops automatically when the
ice cube container is full.
When using the appliance for the first time,
discard ice cubes produced within the first
24 hours for hygiene reasons.
If you have stopped ice cube production for
several days, discard the first 30-40 ice cubes
produced for hygiene reasons.
Information about switching ice cube production on
and off
~ "Switching ice cube production on or off"
on page 16
Water filter
Change the water filter after 6 months at the latest.
If the ice tastes stale, discard the rest of the ice
cubes and the ones produced over the next
24 hours. If the ice still tastes stale, change the
water filter.
Note: If you use an external water filter system, you
can also operate the appliance without a water
filter.Replace the water filter with a bypass cartridge.
Switch off the water filter counter. There is no need
to change the bypass cartridge.
A new water filter or bypass cartridge can be
obtained from customer service or a specialist
dealer.
Exchange water filter or replace with bypass
cartridge
You can change the water filter, or replace it with a
bypass cartridge. The bypass cartridge can remain
in the appliance permanently: it does not need to be
changed.
Note: After installing a water filter or a bypass
cartridge, discard all ice cubes produced over the
first 24 hours.
1. Turn the cap of the water filter counter-clockwise.
2. Take the water filter out.
3. Remove the protective cap of the new water filter
or the new bypass cartridge.
4. Take off the cap of the used water filter and put it
on the new water filter or bypass cartridge.
5. Slide the new water filter or bypass cartridge to
the stop in the filter opening.
Note: The cap must be vertical here.
6. Turn the water filter or bypass cartridge clockwise
to the mark.
Note: If you do not turn the water filter or bypass
cartridge far enough, damage will be caused by
escaping water.
7. When installing a water filter: reset water filter
counter.
When installing a bypass cartridge: switch off
water filter counter.
8. Discard ice cubes produced over the first
24 hours.
9. Drain the water out of the used water filter.
Note: You can dispose of the used water filter with
your household garbage.