Installation guide

In the case of 30" and 36" wide appliances 2 adjacent
furniture doors can be attached instead of one large
door. These furniture doors must be connected to
a metal strip on the rear.
This metal strip can be purchased from customer
service as an optional accessory, see the section on
"Optional accessories" on page 17.
20. Attaching the adjusting rail
to the furniture door
[-i-] The adjusting rail is the most important means of
adjusting the furniture front.
When attaching the metal strip to the furniture doors,
observe the maximum possible length of the screws and
the position of the drill holes. Always screw into the best
load-bearing material of the furniture door.
Never screw into fillers, decorative strips or similar.
IT]If only one furniture door is to be attached to the
door of a 30" or 36" wide appliance, attach the
supplied sandwich plate to the adjusting rail and
lock into position.
19. Loading the appliance door
When attaching the furniture doors, it is recommended
to load the door storage compartments in the appliance
with weights in order to ensure that the gap width is as
precise as possible.
Recommendations:
18" Appliance 22 Ibs / 10 kg
24" Appliance 33 Ibs / 15 kg
30" Appliance 44 Ibs / 20 kg
Q Unscrew the installation support part from the
appliance door.
[-i-] Store the positioning aids, there will be used in
an installation step later.
Q Measure the distance X between the adjusting rail
and the overhead furniture/fixtures.
32