Installation Instructions

Page. 3
Safety
IMPORTANT SAFETY
INSTRUCTIONS
READ AND SAVE THESE
INSTRUCTIONS
INSTALLER: Please leave these Installation Instructions
with this unit for the owner.
OWNER: Please retain these instructions for future
reference.This appliance conforms to the relevant safety
regulations.
The unit must be sealed to the roof, e.g. screws, pipe
connections, roof cutout, etc.
The sides of the roof plate may have sharp edges. Risk of
injury! Wear protective gloves for mounting.
Repairs should only be carried out by qualified specialists.
Check if this blower is recommended by the manufacturer
to be installed with the hood.
WARNING
To avoid electrical shock hazard, before installing,
switch power off at the service panel and lock the
panel to prevent the power from being switched on
accidentally.
CAUTION
FOR GENERAL VENTILATING USE ONLY. Do not use
to exhaust hazardous or explosive materials and
vapors.
State of California Proposition 65 Warning:
 WARNING
This product can expose you to chemicals including
vinyl chloride, which is known to the State of California
to cause cancer and birth defects or other
reproductive harm. For more information go to
www.P65Warnings.ca.gov.
WARNING
To reduce the risk of fire, use only metal ductwork.
WARNING
TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK,
OR INJURY TO PER
SONS, OBSERVE THE
FOLLOWING:
a) Installation work and electrical wiring must be
done by qualified person(s) in accordance with all
applicable codes and regulations, including fire-
related construction.
b) Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of
fuel burning equipment to prevent back drafting.
Follow the heating equipment manufacturer’s
guideline and safety standards such as those
published by the National Fire Protection
Association (NFPA), and the American Society for
Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code
authorities.
c) When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden
utilities.
d) To properly exhaust air, be sure to duct air
outside. DO NOT vent exhaust air into spaces
within walls, ceilings, attics, crawl spaces, or
garages.
WARNING
To reduce the risk of fire or electric
shock, do not use
this blower with any solid-state
speed control device.
This appliance must be grounded. In the event of an
electrical short-circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current.
WARNING
Improper grounding can result in a risk of electric
shock. Consult a qualified electrician if the grounding
instructions are not completely understood, or if
doubt as to whether the appliance is properly
grounded.
None of the packing materials cause pollution to the
environment and all can be recycled for use again. Please
help to protect the environment and dispose of the
packaging in an environment-friendly manner.
Remove all tape and packaging before using the
appliance. Destroy or recycle the packaging after
unpacking the appliance. Never allow children to play with
packaging material.
Equipment Needed Equipment Included
Drill and Bit Anchors (16)
Screwdriver Screws #10 X 1'' (16)
Screws 3.9 x 9.5 (8)