LP Gas Conversion

Installation Instructions English | 6 |
Reassemble the Cooktop
1. For the single piece igniter, carefully feed the wires
through the heat shields, if applicable. Ensure that the
igniter wires do not crimp.
For the two piece igniter, reinstall the heat shield, if
applicable (wire feed not necessary).
2. For the single piece igniter, carefully feed the wires
through the spill trays. Ensure that the igniter wires do
not crimp.
For the two piece igniter, reinstall the spill trays (wire
feed not necessary).
3. Reinstall the Flush Island Trim with T-20 Torx screws.
4. For the single piece igniter, carefully feed the igniter
wires through the burner pedestals.
For the two piece igniter, reinstall the burner pedestals
(wire feed not necessary).
5. Insert the venturi into the burner pedestals. Secure with
the black T-30 Torx screws, starting both before fully
securing either screw. Ensure that the venturi does not
‘lock down’. The venturi should be pulled out smoothly
and easily once the pedestals have been secured.
6. For the single piece igniter, reconnect the igniter wire to
the electrode on the burner base. Carefully feed the
igniter wires back through their burner pedestals while
setting the burner bases back into place. Ensure that
the wires do not crimp or bunch.
For the two piece igniter, set the burner bases back on
the burner pedestals (wire feed not necessary).
7. Secure with the burner bases with T-30 Torx screws,
starting both before fully securing either screw.
8. Replace burner caps and grates.
Continue to “Setting Valve Screws” on
page 7.