Instructions for Use

ManualsBrandsTHERMADOR Manuals48-Inch RangesDual Fuel Freestanding Range

100

Table Of Contents

Do-it-yourself maintenance

Oven light bulb replacement

9 CAUTION

• Make sure the appliance and lights are cool and

power to the appliance has been turned off

before replacing the light bulb(s). Failure to do so

could result in electrical shock or burns.

• The covers must be in place when using the

appliance.

• The covers serve to protect the light bulb from

breaking.

• The covers are made of glass. Handle carefully to

avoid breaking. Broken glass could cause an

injury.

• The light socket is live when the door is open.

Replace only with a recommended light bulb designed for

appliance oven use. DO NOT use a standard household

light bulb in any oven. Call Thermador Customer Care

Center at 1-800-735-4328 or your nearest Thermador

dealer to determine the proper replacement bulb for your

range. You will need to know your range’s model number

and serial number.

Use only 10W, 12V G4 light bulbs. Use a clean, dry cloth to

handle halogen light bulbs. This will increase the life of the

bulb.

To replace the oven light bulb

1. Turn off circuit breaker.

2. Remove the oven racks.

3. Slide the tip of a flat blade screw driver between the

holder clip and the lamp housing (figure, A).

4. Support the glass lens cover with fingers along the

bottom edge to prevent the cover from falling to the

bottom of the oven. Gently twist the flat blade screw

driver to loosen the glass lens cover.

5. Remove the glass lens cover.

6. Remove the bulb by grasping and sliding the bulb

straight back until the two prongs have cleared the

ceramic holder (figure, B).

7. DO NOT touch the glass of the new replacement bulb

with your fingers. It may cause the bulb to fail when it

first lights. Grasp the replacement bulb with a clean

dry cloth. Locate the two prongs in the ceramic

holder, gently poking until the two prongs locate in

the ceramic socket.

8. Press down to seat the bulb (figure, C).

9. Slide the protective lens into the holder clip and push

the other end until the fixing clip snaps back into the

housing (figure, D).

10. Turn on circuit breaker.