Instructions for Use
Table Of Contents
- Home ConnectTM user’s information
- Table of
- Safety
- Safety
- Description
- Before you begin
- Using the rangetop
- Using the oven
- Getting the most out of your appliance
- Home Connect®
- Before calling for service
- Statement of limited product warranty
- Table des
- Définitions de
- Sécurité
- Description
- Avant de commencer
- Utilisation de la table de cuisson
- Tirer le meilleur parti de l’appareil
- Utilisation du four
- Symboles et descriptions
- Configuration initiale
- Réglage du four
- Kitchen timer (minuterie cuisine)
- Oven timer (minuterie de four)
- End timer (fin de la minuterie)
- Fast preheat (préchauffage rapide)
- Panel lock (verrouillage panneau commande)
- Conversion de convection
- Réglage précis du four (décalage de température)
- Probe (sonde thermique)
- Sabbath (Sabbat)
- Remote start (démarrage à distance)
- Home Connect®
- Entretien à faire soi-même
- Avant d’appeler le service technique
- Énoncé de garantie limitée du produit
- Índice de
- Definiciones de
- Seguridad
- Descripción
- Antes de comenzar
- Usar la placa de cocción
- Usar el horno
- Símbolos y descripciones
- Inicio para poner en funcionamiento
- Ajustar el horno
- Kitchen timer (temporizador de cocina)
- Oven timer (temporizador del horno)
- End timer (finalización del temporizador)
- Fast preheat (precalentamiento rápido)
- Panel lock (bloqueo de panel)
- Conversión automática a aire caliente
- Ajuste preciso de la hornilla (desfase de temperatura)
- Probe (sonda térmica)
- Sabbath (Sabbat)
- Remote start (inicio remoto)
- Sacar lo mejor del electrodoméstico
- Configurar Home Connect™
- Cuidado y mantenimiento
- Mantenimiento hecho por usted mismo
- Antes de solicitar servicio
- Declaración de garantía limitada del producto
56
Before calling for service
Before calling for service, check the following to avoid
unnecessary service charges.
Troubleshooting
Symptom Possible cause Remedy
Intermittent igniter sparking • Ceramic igniter is wet or dirty. • Carefully dry or clean igniter.
• Burner ports are clogged. • Clean ports on burner cap with a wire, a
needle or straightened paper clip.
More than four clicks of
igniter before lighting
• Improper fit of burner cap onto
burner base.
• Align burner cap properly on burner
base.
Constant igniter sparking • Range is not properly grounded.
• Electrical power supply is incorrectly
polarized.
• Refer to the Installation Instructions.
Have a qualified electrician ground the
range properly.
Igniters sparking but no
flame ignition.
• Gas supply valve is in “OFF” position. • Restore gas supply to the unit.
Range will not operate
(lights, oven, and surface
burners will not come on)
• No power to the unit. • Check for open circuit breaker.
• Check that power supply line connection
is connected to the proper voltage.
• Oven is in Sabbath mode. • Verify that the oven is not in sabbath
mode. See the ''Using the oven'' section
of the Use and Care Guide.
Oven operates on bake but
fails to operate on timed
bake
• Timer improperly set. • Set timer as outlined in the Use and Care
Guide.
Oven light fails to come on. • Oven light burned out. • Replace the oven light as outlined in the
Use and Care Guide.
Door will not open. • Oven is still in self-clean mode. • If oven is hot, door latch will release
when safe temperature is reached.
Foods in oven are not
cooking sufficiently.
• Rack position is incorrect. • See the ''Using the oven'' section of the
Use and Care Guide.
• Improper cookware. • Refer to ''Cookware recommendations''
in the Use and Care Guide.
• Oven door may not be sealing
properly.
• Clean the oven door gasket. Replace if
worn.
• Appliance not level. • Refer to the Installation Instructions for
instructions on how to level the
appliance.
Hot air is coming from the
appliance.
• It is normal for the cooling process to
push heated air out into the room
when the oven is on.
• During different modes the fan
speed will increase and decrease.
• This is normal.