Installation instructions
Table Of Contents
- Table of
- Safety
- Safety
- READ AND SAVE THESE INSTRUCTIONS
- Before you begin
- General information
- Installation considerations
- Electrical requirements
- Ductwork preparation
- Choosing the correct blower
- Attaching the hood transition
- Wall mount installation
- Discharge direction
- Cabinet installation
- Blower motor installation
- Electrical wire connection
- EXTNCB25W 25 ft. remote and in-line blower extension cable (optional)
- Built-in remote control accessory (optional)
- Make-up air damper relay switch (optional)
- Duct cover installation (optional)
- Installing grease trays, filters and spacers
- Heat lamp installation
- Installer checklist
- Before calling service
- Product data rating label
- Avant de commencer
- Renseignements généraux
- Facteurs à prendre en compte pour l'installation
- Exigences électriques
- Préparation du conduit d’aération
- Configurations de conduits courants
- Choix d'un ventilateur adéquat
- Assemblage du raccord
- Installation murale
- Installation sous une armoire
- Installation du ventilateur
- Branchement des câbles
- Câble de connexion du ventilateur EXTNCB25W (optionnel)
- Commutateur à relais pour clapet d'appoint d'air (facultatif)
- Installation de la commande à distance (optionnel)
- Assemblage du recouvrement de conduit (optionnel)
- Commutateur à relais pour clapet d'appoint d'air (facultatif)
- Installation des filtres, des plateaux à graisse et des pièces d’espacement
- Remplacement des lampes infrarouges
- Liste de vérification à l’intention de l’installateur
- Avant d’appeler le service à la clientèle
- Plaque signalétique du produit
- Antes de comenzar
- Información general
- Factores a tener en cuenta para la instalación
- Exigencias eléctricas
- Preparación del conducto de aireación
- Configuraciones de conductos comunes
- Elección de un ventilador adecuado
- Junta de la campana
- Instalación mural
- Preparación de la pared trasera
- Instalación bajo un armario
- Instalación del motor del ventilador
- Conexión de los cables
- Cable de conexión del ventilador EXTNCB25W (opcional)
- Interruptor de relé de regulador de tiro de aire de compensación (opcional)
- Instalación del mando a distancia (opcional)
- Instalación de la cubierta para el conducto (opcional)
- Instalar filtros, bandejas para la grasa y separadores
- Reemplazo de las lámparas infrarrojas
- Lista de chequeo para el instalador
- Antes de solicitar servicio
- Placa de señalización del producto
- Blank Page
- Blank Page
- Blank Page
- Blank Page
2
Safety
9 IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
INSTALLER: Save these instructions for the local electrical
inspector’s use. Please leave these instructions with this
unit for the owner. Show the owner the location of the
circuit breaker or fuse. Mark it for easy reference.
OWNER: Read and save these instructions. Please retain
these instructions for future reference.
WARNING
If the information in this manual is not
followed exactly, a fire or explosion
may result causing property damage,
personal injury or death.
-- DO NOT store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance.
-- WHAT TO DO IF YOU SMELL GAS
• DO NOT try to light any appliance.
• DO NOT touch any electrical switch.
• DO NOT use any phone in your
building.
• Immediately call your gas supplier from
a neighbor’s phone. Follow the gas
supplier’s instructions.
• If you cannot reach your gas supplier,
call the fire department.
-- Installation and service must be performed
by a qualified installer, service agency or
the gas supplier.
WARNING
Turn off power circuit at service panel and lock out panel
before wiring this appliance. Requirement: 120 VAC, 60
Hz, 15 A or 20 A for some models. Allow the appliance to
cool after the power has been turned off before servicing
the appliance.
WARNING
Automatically operated device
To reduce the risk of injury disconnect from power supply
before servicing.
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
• Use this unit only in the manner intended by the
manufacturer. If you have questions, contact the
manufacturer.
• Before servicing or cleaning unit, switch power off at
service panel and lock the service disconnecting
means to prevent power from being switched on
accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
Contact the manufacturer at the address or telephone
number listed on the back page.
WARNING
DO NOT repair or replace any part of the appliance unless
specifically recommended in the manuals. Improper
installation, service or maintenance can cause injury or
property damage. Refer to this manual for guidance. All
other servicing should be done by an authorized service
provider.
WARNING: ELECTRICAL SHOCK HAZARD
• DO NOT remove connections.
• DO NOT use an extension cord.
• Improper grounding can result in a risk of
electric shock.
• Failure to follow these instructions can result
in death, fire, or electrical shock.