Owner Manual
Page 2 / 2
TROUBLESHOOTING CHECKLIST
Carefully read and follow all Care and Storage, Safety, and Assembly Instructions; the most common
troubleshooting tips are referenced under each set of instructions.
1. The power source may have been interrupted, or the cord may be unplugged.
2. Blower airow may be obstructed. Unplug the blower and check that the intake vent is free from debris. Also
ensure the inatable product is not blocking the intake vent.
3. Check that the zipper near the blower is closed.
4. Inspect fabric for holes and tears. Do not use if product if fabric is damaged.
ASSEMBLY INSTRUCTIONS
STEP 1: Remove all contents from packaging and lay out the deated inatable in a clean, clear area that is
away from sharp objects.
STEP 2: Ensure the zipper at the base of the inatable is zipped shut.
STEP 3: Locate the blower air intake on the inatable and make sure it is clear of fabric or other obstructions,
and that it is facing upright.
STEP 4: Plug the adapter plug into a properly grounded GFCI wall outlet. The blower/fan will immediately
begin to ll the inatable product with air.
It is helpful to lift up on the blower by hand to avoid clogging
the blower air intake.
STEP 5: Once fully inated, clip the included tether ropes into the loops located on the sides of the inatable.
Gently pull on the tether ropes to extend and straighten out with the loose ends lying on the ground. Position
the extended tether ropes with equal spacing distance.
STEP 6: Push the lawn stakes through the loops sewn to the bottom of the inatable to secure the inatable
into the ground. Push the additional lawn stakes into the ground a few inches out from the loose ends of the
tether ropes that are lying on the ground and then attach the loose ends of the tether ropes to the tops of the
lawn stakes. Gently pull and tighten each tether rope to adjust the inatable to an upright and fully secure
position.
WARNING!