VLYNQ Port User's Guide
www.ti.com
3.4 Interrupt Priority Vector Status/Clear Register (INTPRI)
3.5 Interrupt Status/Clear Register (INTSTATCLR)
VLYNQ Port Registers
The interrupt priority vector status/clear register (INTPRI) displays the highest priority vector with a
pending interrupt when read. When writing, only bits [4:0] are valid, and the value represents the vector of
the interrupt to be cleared. The INTPRI is shown in Figure 12 and described in Table 10 .
Figure 12. Interrupt Priority Vector Status/Clear Register (INTPRI)
31 30 16
NOINTPEND Reserved
R-1h R-0
15 5 4 0
Reserved INSTAT
R-0 R/W-0
LEGEND: R/W = Read/Write; R = Read only; - n = value after reset
Table 10. Interrupt Priority Vector Status/Clear Register (INTPRI) Field Descriptions
Bit Field Value Description
31 NOINTPEND Interrupt pending status.
0 Indicates there is a pending interrupt.
1 Indicates that there are no pending interrupts from the interrupt status/clear register.
30-5 Reserved 0 Reserved. Always read as 0. Writes have no effect.
When read, this field displays the vector that is mapped to the highest priority interrupt bit that is
4-0 INSTAT 0-1Fh pending from the interrupt status/clear register, with bit 0 as the highest priority, and bit 31 as the
lowest. Writing the vector value back to this field clears the interrupt.
The interrupt status/clear register (INTSTATCLR) indicates the unmasked interrupt status. The
INTSTATCLR is shown in Figure 13 and described in Table 11 .
Figure 13. Interrupt Status/Clear Register (INTSTATCLR)
31 0
INTCLR
R/W-0
LEGEND: R/W = Read/Write; - n = value after reset
Table 11. Interrupt Status/Clear Register (INTSTATCLR) Field Descriptions
Bit Field Value Description
31-0 INTCLR 0-FFFF FFFFh This field indicates the unmasked status of each interrupt. Writing a 1 to any set bit in this field
clears the corresponding interrupt. If there is a bit set in this register and if the INTLOCAL bit in
the control register (CTRL) is also set, the VLYNQ interrupt (VLQINT) is asserted.
SPRUE36A – September 2007 VLYNQ Port 31
Submit Documentation Feedback