Datasheet

TPS65910 , TPS65910A , TPS65910A3 , TPS659101
TPS659102 , TPS659103 , TPS659104 , TPS659105
TPS659106, TPS659107, TPS659108, TPS659109
SWCS046U –MARCH 2010–REVISED JUNE 2014 www.ti.com
Recommended Operating Conditions (continued)
over operating free-air temperature range (unless otherwise noted)
Note 1: VCC7 should be connected to the highest supply that is connected to the device VCCx pin. The exception is that
VCC2 and VCC4 can be higher than VCC7.
Note 2: VCC2 and VCC4 must be connected together (to the same voltage).
Note 3: If VDD3 boost is used, VAUX33 must be set to 2.8 V or higher and enabled before VDD3.
PARAMETER TEST CONDITIONS MIN NOM MAX UNIT
VDAC LDO
Filtering capacitor C
O(VDAC)
0.8 2.2 2.64 µF
C
O
filtering capacitor ESR 0 500 mΩ
VMMC LDO
Input capacitor C
I(VCC4)
X5R or X7R dielectric 4.7 µF
Filtering capacitor C
O(VMMC)
0.8 2.2 2.64 µF
C
O
filtering capacitor ESR 0 500 mΩ
VAUX33 LDO
Filtering capacitor C
O(VAUX33)
0.8 2.2 2.64 µF
C
O
filtering capacitor ESR 0 500 mΩ
VAUX1 LDO
Input capacitor C
I(VCC3)
X5R or X7R dielectric 4.7 µF
Filtering capacitor C
O(VAUX1)
0.8 2.2 2.64 µF
C
O
filtering capacitor ESR 0 500 mΩ
VAUX2 LDO
Filtering capacitor C
O(VAUX2)
0.8 2.2 2.64 µF
C
O
filtering capacitor ESR 0 500 mΩ
VRTC LDO
Input capacitor C
I(VCC7)
X5R or X7R dielectric 4.7 µF
Filtering capacitor C
O(VRTC)
0.8 2.2 2.64 µF
C
O
filtering capacitor ESR 0 500 mΩ
VDD3 SMPS
Input capacitor C
I(VDD3)
X5R or X7R dielectric 4.7 µF
Filter capacitor C
O(VDD3)
X5R or X7R dielectric 4 10 12 µF
C
O
filter capacitor ESR f = 1 MHz 10 300 mΩ
Inductor L
O(VDD3)
2.8 4.7 6.6 µH
L
O
inductor DC resistor DCR
L
50 500 mΩ
Backup Battery
Battery or superCap supplying VBACKUP 5 10 2000 mF
Backup battery capacitor C
BB
Capacitor supplying VBACKUP 1 40 µF
5 to 15 mF 10 1500
Series resistors Ω
100 to 2000 mF 5 15
I
2
C Interfaces
SDA_SDI, SCL_SCK, SDASR_EN2,
Connected to VDDIO 1.2 kΩ
SCLSR_EN1 external pull-up resistor
Crystal Oscillator (connected from OSC32KIN to OSC32KOUT)
Crystal frequency at specified load cap value 32.768 kHz
Crystal tolerance at 27°C –20 0 20 ppm
Oscillator contribution (not including crystal
Frequency Temperature coefficient. –0.5 0.5 ppm/°C
variation)
Secondary temperature coefficient –0.04 –0.035 –0.03 ppm/°C
2
Voltage coefficient –2 2 ppm/V
Max crystal series resistor at fundamental frequency 90 kΩ
12 Specifications Copyright © 2010–2014, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Links: TPS65910 TPS65910A TPS65910A3 TPS659101 TPS659102 TPS659103 TPS659104
TPS659105 TPS659106 TPS659107 TPS659108 TPS659109