Datasheet

     
  µ   
   
SLOS270D − MARCH 2001 − REVISED JANUARY 2005
8
WWW.TI.COM
POST OFFICE BOX 655303
• DALLAS, TEXAS 75265
TYPICAL CHARACTERISTICS
Table of Graphs
FIGURE
V
IO
Input offset voltage vs Common-mode input voltage 1, 2, 3
CMRR Common-mode rejection ratio vs Frequency 4
Input bias and offset current vs Free-air temperature 5
V
OL
Low-level output voltage vs Low-level output current 6, 8, 10
V
OH
High-level output voltage vs High-level output current 7, 9, 11
V
O(PP)
Peak-to-peak output voltage vs Frequency 12
I
DD
Supply current vs Supply voltage 13
PSRR Power supply rejection ratio vs Frequency 14
A
VD
Differential voltage gain & phase vs Frequency 15
Gain-bandwidth product vs Free-air temperature 16
SR
Slew rate
vs Supply voltage 17
SR Slew rate
vs Free-air temperature
18
φ
m
Phase margin vs Capacitive load 19
V
n
Equivalent input noise voltage vs Frequency 20
Voltage-follower large-signal pulse response 21, 22
Voltage-follower small-signal pulse response 23
Inverting large-signal response 24, 25
Inverting small-signal response 26
Crosstalk vs Frequency 27
Shutdown forward & reverse isolation vs Frequency 28
I
DD(SHDN)
Shutdown supply current vs Supply voltage 29
I
DD(SHDN)
Shutdown pin leakage current vs Shutdown pin voltage 30
I
DD(SHDN)
Shutdown supply current/output voltage vs Time 31, 32