Datasheet
1A 1Y
1 6
2A 2Y
3 4
Absolute Maximum Ratings
(1)
Recommended Operating Conditions
(1)
SN74LVC2G17-Q1
SCES618B – OCTOBER 2004 – REVISED APRIL 2008 ....................................................................................................................................................
www.ti.com
LOGIC DIAGRAM (POSITIVE LOGIC)
over operating free-air temperature range (unless otherwise noted)
MIN MAX UNIT
V
CC
Supply voltage range – 0.5 6.5 V
V
I
Input voltage range
(2)
– 0.5 6.5 V
V
O
Voltage range applied to any output in the high-impedance or power-off state
(2)
– 0.5 6.5 V
V
O
Voltage range applied to any output in the high or low state
(2) (3)
– 0.5 V
CC
+ 0.5 V
I
IK
Input clamp current V
I
< 0 – 50 mA
I
OK
Output clamp current V
O
< 0 – 50 mA
I
O
Continuous output current ± 50 mA
Continuous current through V
CC
or GND ± 100 mA
DBV package 165
θ
JA
Package thermal impedance
(4)
° C/W
DCK package 259
T
stg
Storage temperature range – 65 150 ° C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) The input negative-voltage and output voltage ratings may be exceeded if the input and output current ratings are observed.
(3) The value of V
CC
is provided in the recommended operating conditions table.
(4) The package thermal impedance is calculated in accordance with JESD 51-7.
MIN MAX UNIT
V
CC
Supply voltage Operating 1.65 5.5 V
V
I
Input voltage 0 5.5 V
V
O
Output voltage 0 V
CC
V
V
CC
= 1.65 V – 4
V
CC
= 2.3 V – 8
I
OH
High-level output current – 16 mA
V
CC
= 3 V
– 24
V
CC
= 4.5 V – 32
V
CC
= 1.65 V 4
V
CC
= 2.3 V 8
I
OL
Low-level output current 16 mA
V
CC
= 3 V
24
V
CC
= 4.5 V 32
T
A
Operating free-air temperature – 40 125 ° C
(1) All unused inputs of the device must be held at V
CC
or GND to ensure proper device operation. Refer to the TI application report,
Implications of Slow or Floating CMOS Inputs, literature number SCBA004.
2 Submit Documentation Feedback Copyright © 2004 – 2008, Texas Instruments Incorporated
Product Folder Link(s): SN74LVC2G17-Q1