Datasheet


SBAS290B − JULY 2003 − SEPTEMBER 2004
www.ti.com
5
ELECTRICAL CHARACTERISTICS (continued)
All parameters are specified at T
A
= +25°C with V
CC
= +5V, V
DD
= +3.3V, and a measurement bandwidth from 20Hz to 20kHz, unless otherwise
noted. System clock frequency is equal to 256f
S
for Single and Dual Rate sampling modes, and 128f
S
for Quad Rate sampling mode.
PCM4202
PARAMETER UNITSMAXTYPMINCONDITIONS
DYNAMIC PERFORMANCE
(3)
f
S
= 48kHz, Single Rate BW = 20Hz to 20kHz
Total harmonic distortion + noise THD+N V
IN
= −0.5dBFS, f
IN
= 1kHz −105 −95 dB
Dynamic range V
IN
= −60dBFS, f
IN
= 1kHz, A-Weighted 112 118 dB
Dynamic range, no weighting V
IN
= −60dBFS, f
IN
= 1kHz 116 dB
Channel separation 100 120 dB
f
S
= 96kHz, Dual Rate BW = 20Hz to 40kHz
Total harmonic distortion + noise THD+N V
IN
= −0.5dBFS, f
IN
= 1kHz −105 dB
Dynamic range V
IN
= −60dBFS, f
IN
= 1kHz, A-Weighted 118 dB
Dynamic range, no weighting V
IN
= −60dBFS, f
IN
= 1kHz 112 dB
Channel separation 120 dB
f
S
= 192kHz, Quad Rate BW = 20Hz to 40kHz
Total harmonic distortion + noise THD+N V
IN
= −0.5dBFS, f
IN
= 1kHz −103 dB
Dynamic range V
IN
= 0V
RMS
, A-Weighted 117 dB
Dynamic range, no weighting V
IN
= 0V
RMS
108 dB
Channel separation 120 dB
DSD Output, 64f
S
Rate DSDBCK = 2.8224MHz
Total harmonic distortion + noise THD+N V
IN
= −0.5dBFS, f
IN
= 1kHz −102 dB
Dynamic range V
IN
= −60dBFS, f
IN
= 1kHz, A-Weighted 115 dB
Channel separation 120 dB
DSD Output, 128f
S
Rate DSDBCK = 5.6448MHz
Total harmonic distortion + noise THD+N V
IN
= −0.5dBFS, f
IN
= 1kHz −105 dB
Dynamic range V
IN
= −60dBFS, f
IN
= 1kHz, A-Weighted 118 dB
Channel separation 120 dB
(1)
Applies to the RST input, pin 19.
(2)
Single, Dual, and Quad Rate sampling modes are described within this data sheet.
(3)
Dynamic performance parameters are measured using an Audio Precision System Two Cascade or Cascade Plus test system. The
measurement bandwidth is limited by using the Audio Precision 22Hz high-pass filter in combination with the Audio Precision 20kHz, f
S
/2, or
a user-defined 40kHz low-pass filter. All A-weighted measurements are performed using the Audio Precision A-weighting filter in combination
with the previously mentioned filters.