Datasheet

3 OPA134/2134/4134
®
PACKAGE
DRAWING TEMPERATURE
PRODUCT PACKAGE NUMBER
(1)
RANGE
Single
OPA134PA 8-Pin Plastic DIP 006 –40°C to +85°C
OPA134UA SO-8 Surface-Mount 182 –40°C to +85°C
Dual
OPA2134PA 8-Pin Plastic DIP 006 –40°C to +85°C
OPA2134UA SO-8 Surface-Mount 182 –40°C to +85°C
Quad
OPA4134PA 14-Pin Plastic DIP 010 –40°C to +85°C
OPA4134UA SO-14 Surface-Mount 235 –40°C to +85°C
NOTE: (1) For detailed drawing and dimension table, please see end of data
sheet, or Appendix C of Burr-Brown IC Data Book.
ELECTROSTATIC
DISCHARGE SENSITIVITY
This integrated circuit can be damaged by ESD. Burr-Brown
recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling
and installation procedures can cause damage.
ESD damage can range from subtle performance degrada-
tion to complete device failure. Precision integrated circuits
may be more susceptible to damage because very small
parametric changes could cause the device not to meet its
published specifications.
ABSOLUTE MAXIMUM RATINGS
(1)
Supply Voltage, V+ to V– .................................................................... 36V
Input Voltage .................................................... (V–) –0.7V to (V+) +0.7V
Output Short-Circuit
(2)
.............................................................. Continuous
Operating Temperature ................................................. –40°C to +125°C
Storage Temperature..................................................... –55°C to +125°C
Junction Temperature ...................................................................... 150°C
Lead Temperature (soldering, 10s) ................................................. 300°C
NOTES: (1) Stresses above these ratings may cause permanent damage.
(2) Short-circuit to ground, one amplifier per package.
TYPICAL PERFORMANCE CURVES
At T
A
= +25°C, V
S
= ±15V, R
L
= 2kΩ, unless otherwise noted.
TOTAL HARMONIC DISTORTION + NOISE
vs FREQUENCY
Frequency (Hz)
THD+Noise (%)
0.1
0.01
0.001
0.0001
0.00001
10 100 1k 10k 100k
2kΩ
600Ω
R
L
V
O
= 3Vrms
G = +1
G = +10
SMPTE INTERMODULATION DISTORTION
vs OUTPUT AMPLITUDE
Output Amplitude (Vpp)
IMD (%)
1
0.1
0.010
0.001
0.0005
5
30m
0.1 1
10 30
G = +1
f = 1kHz
R
L
= 2kΩ

Baseline
OP176
OPA134
OPA134
The information provided herein is believed to be reliable; however, BURR-BROWN assumes no responsibility for inaccuracies or omissions. BURR-BROWN assumes
no responsibility for the use of this information, and all use of such information shall be entirely at the user’s own risk. Prices and specifications are subject to change
without notice. No patent rights or licenses to any of the circuits described herein are implied or granted to any third party. BURR-BROWN does not authorize or warrant
any BURR-BROWN product for use in life support devices and/or systems.
PACKAGE/ORDERING INFORMATION