Datasheet

ManualsBrandsTEXAS INSTRUMENTS ManualsMicrocontrollers, Microprocessors & QuartzesEmbedded microcontroller LQFP 64 (10x10) 16-Bit 16 MHz I/O number 48

MSP430F23x

MSP430F24x(1)

MSP430F2410

SLAS547I –JUNE 2007–REVISED DECEMBER 2012

www.ti.com

This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with

appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.

ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more

susceptible to damage because very small parametric changes could cause the device not to meet its published specifications.

DESCRIPTION

The Texas Instruments MSP430™ family of ultra-low power microcontrollers consists of several devices featuring

different sets of peripherals targeted for various applications. The architecture, combined with five low-power

modes, is optimized to achieve extended battery life in portable measurement applications. The device features a

powerful 16-bit RISC CPU, 16-bit registers, and constant generators that contribute to maximum code efficiency.

The calibrated digitally controlled oscillator (DCO) allows wake-up from low-power modes to active mode in less

than 1 µs.

The MSP430F23x, MSP430F24x(1), and MSP430F2410 series are microcontroller configurations with two built-

in 16-bit timers, a fast 12-bit A/D converter (not MSP430F24x1), a comparator, four (two in MSP430F23x)

universal serial communication interface (USCI) modules, and up to 48 I/O pins. The MSP430F24x1 devices are

identical to the MSP430F24x devices, with the exception that the ADC12 module is not implemented. The

MSP430F23x devices are identical to the MSP430F24x devices, with the exception that a reduced Timer_B, one

USCI module, and less RAM are integrated.

Typical applications include sensor systems, industrial control applications, and hand-held meters.

Table 1. Available Options

PACKAGED DEVICES

(1)(2)

PLASTIC 64-PIN QFP (PM) PLASTIC 64-PIN QFN (RGC)

MSP430F233TPM MSP430F233TRGC

MSP430F235TPM MSP430F235TRGC

MSP430F247TPM MSP430F247TRGC

MSP430F2471TPM MSP430F2471TRGC

-40°C to 105°C MSP430F248TPM MSP430F248TRGC

MSP430F2481TPM MSP430F2481TRGC

MSP430F249TPM MSP430F249TRGC

MSP430F2491TPM MSP430F2491TRGC

MSP430F2410TPM MSP430F2410TRGC

(1) For the most current package and ordering information, see the Package Option Addendum at the end

of this document, or see the TI web site at www.ti.com.

(2) Package drawings, thermal data, and symbolization are available at www.ti.com/packaging.

Development Tool Support

All MSP430 microcontrollers include an Embedded Emulation Module (EEM) allowing advanced debugging and

programming through easy to use development tools. Recommended hardware options include the following:

• Debugging and Programming Interface

– MSP-FET430UIF (USB)

– MSP-FET430PIF (Parallel Port)

• Debugging and Programming Interface with Target Board

– MSP-FET430U64 (PM package)

• Standalone Target Board

– MSP-TS430PM64 (PM package)

• Production Programmer

– MSP-GANG430