User's Manual

Hardware Installation

www.ti.com

C.1 Hardware Installation

Table C-1 shows the USB VIDs and PIDs used in MSP430 tools.

Table C-1. USB VIDs and PIDs Used in MSP430 Tools

Tool USB VID USB PID INF File Name

eZ430-F2013 0x0451 0xF430 usbuart3410.inf

eZ430-RF2500 0x0451 0xF432 430CDC.inf

eZ430-RF2780 0x0451 0xF432 430CDC.inf

eZ430-RF2560 0x0451 0xF432 430CDC.inf

MSP-WDSxx "Metawatch" 0x0451 0xF432 430CDC.inf

eZ430-Chronos 0x0451 0xF432 430CDC.inf

MSP-FET430UIF

(1)

0x2047 0x0010 msp430tools.inf

LaunchPad (MSP-EXP430G2) 0x0451 0xF432 430CDC.inf

MSP-EXP430FR5739 0x0451 0xF432 430CDC.inf

MSP-EXP430F5529 0x0451 0xF432 430CDC.inf

(1)

The older MSP-FET430UIF used with IAR versions before v5.20.x and CCS versions before v5.1 has VID 0x0451 and PID

0xF430. With the firmware update, it is updated to the 0x2047 and 0x0010, respectively.

1. Before connecting of the USB Debug Interface with a USB cable to a USB port of the PC the one of

IDEs (CCS or IAR) should be installed. The IDE installation isntalls also drivers for USB Debug

Interfaces without user interaction. After IDE installation the USB Debug Interface can be connected

and will be ready to work within few seconds.

2. The driver can be also installed manually. After plug in the USB Debug Interface to USB port of the PC

the Hardware Wizard starts automatically and opens the "Found New Hardware Wizard" window.

3. Select "Install from a list or specific location (Advanced)" (see Figure C-1).

Figure C-1. Windows XP Hardware Wizard

142

Hardware Installation Guide SLAU278I–May 2009–Revised May 2012

Submit Documentation Feedback