Datasheet

DRV101
3
SBVS008B
www.ti.com
CONNECTION DIAGRAMS
Top Front View TO-220, DDPAK
Supply Voltage, V
S
.............................................................................. 60V
Input Voltage .......................................................................... –0.2V to V
S
PWM Adjust Input .................................................................. –0.2V to V
S
Delay Adjust Input ................................................ –0.2V to V
S
(24V max)
Operating Temperature Range ......................................–40°C to +125°C
Storage Temperature Range .........................................–65°C to +150°C
Junction Temperature .................................................................... +150°C
Lead Temperature (soldering, 10s)
(2)
........................................... +300°C
NOTES: (1) Stresses above these ratings may cause permanent damage.
Exposure to absolute maximum conditions for extended periods may de-
grade device reliability. (2) Vapor-phase or IR reflow techniques are recom-
mended for soldering the DRV101F surface-mount package. Wave soldering
is not recommended due to excessive thermal shock and “shadowing” of
nearby devices.
ABSOLUTE MAXIMUM RATINGS
(1)
ELECTROSTATIC
DISCHARGE SENSITIVITY
This integrated circuit can be damaged by ESD. Texas Instruments
recommends that all integrated circuits be handled with appropriate
precautions. Failure to observe proper handling and installation
procedures can cause damage.
ESD damage can range from subtle performance degradation to
complete device failure. Precision integrated circuits may be more
susceptible to damage because very small parametric changes
could cause the device not to meet its published specifications.
7-Lead
Stagger-Formed
TO-220
NOTE: Tabs are electrically connected to ground (pin 4).
1234
5
6 7
7-Lead
DDPAK
Surface-Mount
PWM
PWM
Gnd Out
V
S
Delay
In
1234
5
6
Flag
Gnd Out
V
S
Delay
In
Flag
7
PACKAGE/ORDERING INFORMATION
For the most current package and ordering information, see the Package Ordering Addendum at the end of this data sheet.