Datasheet
www.ti.com
ABSOLUTE MAXIMUM RATINGS
(1)
RECOMMENDED OPERATING CONDITIONS
(1)
SN74ALVCH32973
16-BIT BUS TRANSCEIVER AND TRANSPARENT D-TYPE LATCH
WITH EIGHT INDEPENDENT BUFFERS
SCES436C – APRIL 2003 – REVISED SEPTEMBER 2004
over operating free-air temperature range (unless otherwise noted)
MIN MAX UNIT
V
CC
Supply voltage range -0.5 4.6 V
Except I/O and D input ports
(2)
-0.5 4.6
V
I
Input voltage range V
I/O and D input ports
(2) (3)
-0.5 V
CC
+ 0.5
V
O
Output voltage range
(2) (3)
-0.5 V
CC
+ 0.5 V
I
IK
Input clamp current V
I
< 0 -50 mA
I
OK
Output clamp current V
O
< 0 -50 mA
I
O
Continuous output current ± 50 mA
Continuous current through each V
CC
or GND ± 100 mA
θ
JA
Package thermal impedance
(4)
GKE/ZKE package 40 ° C/W
T
stg
Storage temperature range -65 150 ° C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) The input negative-voltage and output voltage ratings may be exceeded if the input and output current ratings are observed.
(3) This value is limited to 4.6 V maximum.
(4) The package thermal impedance is calculated in accordance with JESD 51-7.
MIN MAX UNIT
V
CC
Supply voltage 1.65 3.6 V
V
CC
= 1.65 V to 1.95 V 0.65 × V
CC
V
IH
High-level input voltage V
CC
= 2.3 V to 2.7 V 1.7 V
V
CC
= 3 V to 3.6 V 2
V
CC
= 1.65 V to 1.95 V 0.35 × V
CC
V
IL
Low-level input voltage V
CC
= 2.3 V to 2.7 V 0.7 V
V
CC
= 3 V to 3.6 V 0.8
V
I
Input voltage 0 V
CC
V
V
O
Output voltage 0 V
CC
V
V
CC
= 1.65 V -4
V
CC
= 2.3 V -12
I
OH
High-level output current mA
V
CC
= 2.7 V -12
V
CC
= 3 V -24
V
CC
= 1.65 V 4
V
CC
= 2.3 V 12
I
OL
Low-level output current mA
V
CC
= 2.7 V 12
V
CC
= 3 V 24
∆ t/ ∆ v Input transition rise or fall rate 10 ns/V
T
A
Operating free-air temperature -40 85 ° C
(1) All unused control inputs of the device must be held at V
CC
or GND to ensure proper device operation. Refer to the TI application report,
Implications of Slow or Floating CMOS Inputs, literature number SCBA004.
5