User's Manual

⑮. Water-seal Plug
⑯. Power/Volume Switch
⑰. RF Output Power Selector
⑱. Mode Selector Switch
⑲. Group Selector Switch
BATTERY INSTALLATION (OR REPLACEMENT)
(OR REPLACEMENT)
 Please follow as following instruction 1,2, and 7 with original rechargeable battery pack.
 Please follow for whole procedure with optional battery clip (BC390).
1. Press and hold the 2 Latch Levers on the side of Radio
Housing at the same time and pull down the Battery Clip to
remove from the Radio Housing.
2. Release the Clamp located at both sides of Battery Cap by
using the right hand side of Latch Lever on the Radio
Housing.
Remarks: The left hand side of Latch Lever is wider than the right
hand side, so it is not convenient to use for releasing the Clamp.
3. Pull the Battery Cap to remove from Battery Housing.
4. Insert 6 cells of fresh AA Alkaline battery in the Battery Housing.
Remember to install the batteries with correct direction of polarity
as shown on the figure.