User Guide

ME910G1 Preliminary HW Design Guide
1VV0301593 Rev.2 Page 89 of 95 2020-01-13
Information on test modes and additional testing requirements
The module has been evaluated in mobile stand-alone conditions. For different
operational conditions from a stand-alone modular transmitter in a host (multiple,
simultaneously transmitting modules or other transmitters in a host), additional testing
may be required (collocation, retesting…)
If this module is intended for use in a portable device, you are responsible for separate
approval to satisfy the SAR requirements of FCC Part 2.1093 and IC RSS-102.
Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC
transmitter rules) listed on the grant, and that the host product manufacturer is responsible
for compliance to any other FCC rules that apply to the host not covered by the modular
transmitter grant of certification. If the grantee markets their product as being Part 15
Subpart B compliant (when it also contains unintentional-radiator digital circuity), then the
grantee shall provide a notice stating that the final host product still requires Part 15 Subpart
B compliance testing with the modular transmitter installed. The end product with an
embedded module may also need to pass the FCC Part 15 unintentional emission testing
requirements and be properly authorized per FCC Part 15.