User's Manual

GE866-DUAL Hardware User Guide
1VV0301051 Rev. 2 – 2014-04-07 7
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights
Reserved. Page 65 of 82
Mod. 0805 2011-07 Rev.2
13.3. Recommended foot print for the
application (dimensions in mm):
In order to easily rework the GE866 is suggested to consider
on the application a 1.5 mm placement inhibit area around the
module.
It is also suggested, as common rule for an SMT component, to
avoid having a mechanical part of the application in direct
contact with the module.
NOTE:
In the customer application, the region under WIRING INHIBIT
(see figure above) must be clear from signal or ground paths .
Top View