User's Manual

Section 5 – Programming (Continued)
25 11/5/2003
becomes a switch to toggle between “A” and “B” or
both. Where “A” and “B” are Select 2 and Select 1
outputs respectively.
NOTE
THE “A” LED LIT CAUSES THE SELECT 2 RELAY
TO CLOSE. THE “B” LED CAUSES THE SELECT 1
RELAY TO CLOSE.
Tandem For Hoist, Trolley or Bridge. (Normally
checked).
This function appears if a four motor system or select
function is chosen. Normally the box is checked
meaning “Both A and B” operation is enabled (both
MAIN and Aux or Select 2 and Select 1 can be ON at
the same time). Removing the check from the box by
tapping on it disables the “Both” function. (“A” and “B”
will not come ON at the same time). This function maps
to Pendant Switch 4 position 3, if SW4 position 3 is
switched “ON” un-check Tandem box on PDA.
Position 4 Invert Crane Select Aux. Outputs.
(Normally not checked).
This function appears if a system using select is
programmed in. Turning this switch “ON” inverts the
select function operation so that the relay closes for the
unselected function. This function maps to Pendant
Switch 4 position 4, if SW4 position 4 is switched “ON”
check Invert box on PDA.
This completes the 10K 2-speed programming, when
completed with the above tap “Save”.
Save will take you back to the Initial start screen. At this
point select another Bank to program or Go to Section
5-4. Saving, Downloading, Reading the Programs and
Other PDA Functions on page 28.
NOTE
TO PROGRAM OR READ DATA FROM
THE telePendant, THE TRANSMITTER
MUST BE TURNED ON AND IN BANK
FIVE (5).
Crane control enabled
Tandem Invert
System 10K Freq AK01
Setup Bank #
A1
Receiver access code
1
0
B1 1
0
S3-1
1
0
Timer
Switch conf.: H,T,B
Main/Aux Aux only
Save
Cancel
Multibox
Auto Turn Off Active ESTOP
RX Setting
15