User's Manual

Section 5 – Programming (Continued)
19 11/5/2003
THE PRINTED CIRCUIT BOARD NEAR THE
RESPECTIVE SWITCHES. DETERMINE THEIR
ORIENTATION. THE SWITCHES MAY NUMBER
FROM LEFT TO RIGHT OR RIGHT TO LEFT. LOOK
FOR THE NUMBERING ON THE SWITCHES.
MATCH ACCESS CODES A1, A2, - -- B1, B2 ETC.
After changing the access code, test the receiver (s) with
a matching transmitter. (If the red LED “Wrong Access
Code” comes ON in the receiver only while transmitting
receiver the code does not match, recheck the access
code settings). See receiver manual for LED location.
WARNING
THE ACCESS CODES IN THE RECEIVER ARE
UNIQUE AND FACTORY PRESET. DO NOT
CHANGE THESE ACCESS CODES UNLESS YOU
ARE REPLACING AN EXISTING RECEIVER AND
ITS ACCESS CODE. CHANGING THIS CODE
COULD MAKE IT COMMON WITH ANOTHER
RECEIVER ACCESS CODE, WHICH COULD MOVE
ANOTHER CRANE. NO TWO SYSTEMS IN ANY
LOCATION SHOULD EVER HAVE THE SAME
ACCESS CODES INDEPENDENT OF FREQUENCY.
FAILURE TO FOLLOW THIS WARNING COULD
RESULT IN SERIOUS INJURY OR DEATH AND
DAMAGE TO EQUIPMENT.
5-2. Multibox.
Multibox Operation. (Optional, for receivers with
Multibox option only).
Do not use on InteleSmart Receivers. Use Group
Code feature, see InteleSmart Receiver Manual.
WARNING
IF YOUR RECEIVER WAS NOT ORDERED WITH
MULTIBOX DO NOT ATTEMPT TO PROGRAM
MULTIBOX IN THE FIELD. TELEMOTIVE MUST
COORDINATE ACCESS CODE ASSIGNMENTS
WITH THE TRANSMITTERS PRIOR TO ENABLING
MULTIBOX. PLEASE CONTACT TELEMOTIVE IF
YOU NEED TO ADD MULTIBOX. FAILURE TO
FOLLOW THIS WARNING COULD RESULT IN
SERIOUS INJURY OR DEATH AND DAMAGE TO
EQUIPMENT.
WARNING
IF YOUR UNIT HAS MULTIBOX DO NOT
ATTEMPT TO PROGRAM ADDITIONAL
TRANSMITTERS IN THE FIELD. TELEMOTIVE
MUST COORDINATE ACCESS CODE AS-
SIGNMENTS WITH THE NEW TRANSMITTERS
PRIOR TO EXPANDING MULTIBOX. PLEASE
CONTACT TELEMOTIVE IF YOU NEED TO ADD
ADDITIONAL TRANSMITTERS. FAILURE TO
FOLLOW THIS WARNING COULD RESULT IN
SERIOUS INJURY OR DEATH AND DAMAGE TO
EQUIPMENT.
Many receivers have Multibox capability that allows up
to 8 transmitters to access a single system. Only one
transmitter may control the receiver(s) at a given time.
Access is on a first come first serve basis. Once a
transmitter has gained control, another transmitter may
not access the receiver(s) until the controlling transmitter
relinquishes control by transmitting an OFF command to
the receiver(s) or the receiver(s) times out due to
inactivity.
The first transmitter to send an ON command after the
receiver has been released will then gain control of the
receiver(s). The number of transmitters (1-8) allowed to
control the receiver(s) is dip switch selectable on the
Receiver Board.
NOTE
THE DESIRED MULTIBOX TRANSMITTERS MUST
HAVE CONSECUTIVE ACCESS CODES
BEGINNING FROM THE FIRST ACCESS CODE.