User's Manual

ManualsBrandsTelematics Wireless ManualsElectronicsWater Meter Transceiver

Draft

User Manual

TMW-40U

TMW-40U FCC ID: NTAXMETER5

Manufacturer: Tadiran-Telematics Ltd.

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received,

including interference that may cause undesired operation.

Note:

The digital portion of the transceiver has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interfere

nce to radio communications. However, there is no guarantee that interference will

not occur in a particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

Connect the equipment into an outlet

on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Summary of content (5 pages)

PAGE 1
Draft User Manual TMW-40U TMW-40U FCC ID: NTAXMETER5 Manufacturer: Tadiran-Telematics Ltd. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
PAGE 2
Draft Installation Following information will be included in the User Manual - The user and the installer should be aware that changes and modifications not expressly approved by Tadiran Telematics could void the user’s authority to operate the equipment. - This equipment shall be installed by professional personnel.
PAGE 3
Draft - There are 3 types of the pits: metal, concrete and plastic. The covers of the pits are made of metal, concrete or plastic and, in case of concrete or plastic pits, may or may not include small rectangular lid at the center of the cover. The lids can be either metal or plastic. Allowable configurations of the pits and its covers are shown on the following pictures: Metal Pit Concrete Pit w. concrete cover and metal lid Plastic Pit w. plastic cover and metal lid Plastic Pit w.
PAGE 4
Draft Special instructions for installation in the concrete or plastic pits. When installing the equipment in the pit made of plastic or concrete, regardless of the type of the cover, a special adhesive sticker shall be attached to the unit as described in the drawings (see attached picture). The sticker is copper foil sticker (e.g. type 3M 1181, PPI 9115 or compatible), intended for permanent adhesion.
PAGE 5
Draft