User manual
- 18 -
Automatic channel scan
With this menu, you can search selected or all satellites. To do this, select “Automatic channel scan” in the
Installation menu, by using the “ ”/“ ” buttons. If you press OK button, the “Automatic channel scan” menu
will appear. Settings in this screen may vary in accordance with antenna type selection dened in rst time
installation. You can set satellite values as desired. Press GREEN button to scan selected satellite. Press
BLUE button to view transponder list. You can use OK button to scan all satellites.
You can choose to load Pre-Programmed List or perform Regular Scan. Refer to the explanations in the Fist
Time Installation section for more details.
Antenna Installation
Settings in this screen may vary in accordance with antenna type selection dened in rst time installation.
You can set satellite values as desired by using the navigation buttons.
Satellite List
Use “ ” or “ ” button to select Satellite List and then press OK button to see listed satellites on your set-top
box. You can use Up/Down or RED/GREEN buttons to navigate in Satellite List menu. If you want to add a new
satellite press YELLOW button and enter the details of the desired satellite. To delete a satellite in the list press
BLUE button. A message will appear asking you whether to delete the selected satellite. Select Yes and press
OK button to delete. To edit a satellite in the list press OK button and Edit Satellite screen will be displayed. You
can change the name, orbital position and reference transponder for the selected satellite from this screen. Press
the EXIT button on the remote control to exit.
First Time Installation
This section is same with initial installation part. Please refer to Menu interface/First time installation section
for more information.
Conguration
You can congure the settings of your set-top box. Select Conguration from Setup menu and press “OK” to view
this menu. Press the “EXIT” button on the remote control to exit.