User's Guide

Meeting Room Display Tablet User Guide T0006377_UG Version 0.5
TEKTELIC Communications Inc. Confidential Page 12 of 28
2 Commissioning
The steps for commissioning the Meeting Room Display Tablet are managed through a versatile
Book Now Application (BNA) [1]. BNA provides an interface that guides the user through the
steps to commission the Tablet and allocating it to a meeting room. BNA registers the Tablet
onto the Network server using the unique identifier (EUI) of the Tablet. A high-level diagram of
the Meeting Room Display Tablet’s infrastructure is shown in Figure 2-1. It is recommended to
refer to the BNA user guide [1] for detailed instructions on commissioning the Tablet.
Facility DB
Mail server
(Calendar)
Book Now
Application (BNA)
Network Server
Device DB
Meeting Room
Tablet
Gateway
LoRa
Figure 2-1: Meeting Room Display Tablet’s infrastructure
2.1 Power Up/Down Procedure
 Battery powered version of Tablet is shipped with the batteries installed along with pull
tabs that prevent the Tablet from turning on during shipment.
 Once the Tablet is configured on the BNA, turn on the Tablet by removing the battery
pull tabs or providing external power depending on the model.
 See section 5.3 for LED behaviour during boot-up.
 To turn off the Tablet the batteries or external power must be removed. The unit must
remain un-powered for 1 minute to completely reset.
 The reset switch of the Tablet is accessible through a pin hole in the bottom side of the
Tablet as shown in Figure 1-2. See section 5.3 for LED behaviour during boot-up.