Data Brochure

- Data Brochure

Adaptor Plate 007

D 007

05/07

Installation - Adaptor Plate 007

The Adaptor Plate 007 allows for installation of a small enclosure Room Temperature Unit

(RTU) or Indoor Sensor or Thermostat on to a 2” x 4” electrical box. The adapter plate can

be mounted vertical or horizontal and is designed to allow wiring to feed through in any

position. Included with the adaptor plate are surface painted screws for mounting to the 2” x

4” electrical box and screws to mount the RTU / Indoor Sensor to the plate.

STEP ONE

GETTING READY

Check the contents of this package. If any of the contents listed are missing or damaged,

please contact your wholesaler or tekmar sales representative for assistance.

Type 007 includes: • One Adaptor Plate 007 • Two electrical cover screws • Two 5/16”

screws • One Data Brochure D 007

STEP TWO

MOUNTING THE PLATE

The Adaptor Plate is mounted onto a standard 2” x 4” electrical box using the supplied

screws. Ensure the electrical box is properly insulated and protected from cold drafts. All

required RTU or Indoor sensor wiring must be pulled through the existing top left hand hole

of the adaptor plate. The adaptor plate may be mounted horizontally or vertically using the

electrical cover screws provided.

STEP THREE

MOUNTING THE SENSOR / RTU ————————

Insert the wiring through the hole provided in the back of the sensor or RTU enclosure,

and connect them to the wiring terminals as described in the applicable Sensor / RTU

Data Brochure. Attach the sensor or RTU to the adaptor plate using the supplied 5/16”

screws.

Do not over tighten screws as the plastic molding may strip.

PAGE 1
- Data Brochure D 007 Adaptor Plate 007 05/07 The Adaptor Plate 007 allows for installation of a small enclosure Room Temperature Unit (RTU) or Indoor Sensor or Thermostat on to a 2” x 4” electrical box. The adapter plate can be mounted vertical or horizontal and is designed to allow wiring to feed through in any position. Included with the adaptor plate are surface painted screws for mounting to the 2” x 4” electrical box and screws to mount the RTU / Indoor Sensor to the plate.
PAGE 2
Installation - Adaptor Plate 007 Stud 007 Adaptor Plate Thermostat Base Switch Box Thermostat © 2007 3 1/4” (83 mm) D 007 - 05/07 2 of 4
PAGE 4
Technical Data ADAPTOR PLATE 007 Literature Packaged weight Dimensions Approvals Ambient conditions Included D 007 0.46 lb. (210 g), Enclosure J, white PVC plastic 4-1/2” H x 2-7/8” W x 3/16” D (115 x 73 x 4.8 mm) CSA C US, meets ICES & FCC regulations for EMI/RFI. Indoor use only, -20 to 120°F (-30 to 50°C) two #6 x 5/16” self-tapping screws two #6-32 x 1/2” white cover plate screws Limited Warranty and Product Return Procedure Limited Warranty The liability of tekmar under this warranty is limited.