User's Manual

Administrative Guide Quick Installation

5. Quick Installation

This Quick Installation help to you install the product quickly and easily. For detailed

instructions on installation, and further setup option, please refer to the configuration

chapter.

5.1 Connecting the EUT

(1) Place GW6000 in an optimum location.

(2) Connect the included Category 5 Ethernet network cable to the EUT’s LAN port

or WAN port. Then connect the other end of the network cable to a switch or hub or

directly your PC’s Ethernet port. The EUT will then be connected to your 10/100

network.

(3) Connect the AC power adapter to the EUT’s Power port. Only use the power

adapter supplied with the EUT. Use of a different adapter may result in product

damage.

(4) Press the reset button on the rear panel to set the EUT to factory default settings.

(5) Now that you have connected the EUT to your network, you are ready to begin

setting it up. The Setup Wizard will take you through all necessary steps to help you to

configure the EUT easily.

5.2 Wizard Setup

This system administrator can configure the EUT remotely or locally via a Web

Browser. When EUT return to default factory settings, its LAN address is

“192.168.1.1” , and username is “admin”, password is “admin”.

Wizard Setup allows system administrator to select the appropriate operation mode and

configure the corresponding setting step by step. The following eight items are

supported.

z WAN Settings

z LAN Settings

z Wireless Basic

z Wireless Security

z Internet Time

z Numbering Plan

z IP Trunk

z Call Routing Table

In the configuration, the administrator presses “Next” or “Back” button to choose the

setting item. If pressing “Exit & Reboot”, it will asks whether store settings. If choose Yes,

the settings will be saved and the EUT will be reboot automatically. From now on, if

entering the EUT Web configuration, it goes to home page “Intelligent Gateway”

directly.

5.2.1 WAN Setting

There are three modes that you can configure WAN IP address: Static IP mode, DHCP

mode and PPPoE mode. You can also select to enable or disable Firewall and IGMP.

Note that Network Address Translation function (NAT) is default enabled and is not

showing on the page to prevent it from being disabled.