Operation Manual

The dishes were not
loaded correctly.
See notes in " Loading the Dishwasher Baskets ".
Select a more intensive programme.
See" Wash Cycle Table ."
Use more detergent, or change your detergent.
Rearrange the items so that the sp ayer can rotate freely.r
Clean and/or fit the filter combination correctly.
Clean the sp ay arm jets. See "Cleaning the Spray
Arms".
r
Use less detergent if you have soft water and select
a shorter cycle to wash the glassware and to clean
them. Check the rinse aid is not empty.
Use a mild abrasive cleaner to eliminate those marks.
R
dispenser. Select a longer wash cycle.
eposition dishes correctly away from the detergent
Load the dishwasher as suggested in the directions.
Increase the amount of rinse-aid/Refill the rinse-aid
dispenser.
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam can
escape. Begin unloading the dishwasher only once the
dishes are barely warm by touching.
In short program the rinse temperature is lower.
Choose a program with a high rinse temperature.
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
The program was
not powerful enough.
Not enough detergent
was dispensed.
Items are blocking
the path of sp ay arms.r
The filter combination
is not clean or
is not correctly fitted.
This may cause
the sp ay arm jets
get blocked.
r
Combination of soft
water and too much
detergent.
Aluminum utensils
have rubbed against
dishes.
Dishes block detergent
cups from opening
Improper loading
Too little rinse-aid
Dishes are removed
too soon.
Wrong program
selection
Using cutlery with
a low-quality coating
When some malfunctions occur, the appliance will display error codes to warn you:
If overflow occurs, turn off the main water supply before calling a service.
If there is water in the base pan because of an overfill or small leak,
the water should be removed before restarting the dishwasher.
18
Unsatis
-factory
washing
result
Unsatis
-factory
drying
result
Longer inlet time.
Faucet is not opened, or water intake is restricted,
or water pressure is too low.
Some element of the dishwasher has leaked.
Overflow.